Learning how to frontside 180 on a Tech Deck is the best way to add your first spin trick after the ollie. This guide shows you the finger placement, the wind up, the spin, the catch, and a 10 minute drill. You will also fix the three mistakes that stop most beginners and see what to learn next.
Your ollie is clean, and now you want a trick that turns the board around. Learning how to frontside 180 on a Tech Deck is the natural next step. The board jumps, spins halfway around, and lands facing the other way, with you still on top of it. It looks smooth, it feels exciting, and it opens the door to 360s, boardslides, and every spin trick after it.
The hard part is the timing. You have to wind up your shoulders, pop, spin, and catch, all in less than a second. That sounds fast, but each part is simple on its own. The good news is that you can learn it on a desk in a small space. You do not need a ramp, a rail, or a skatepark. In this guide you will learn the finger placement, the five steps, the three mistakes to avoid, and a 10 minute daily drill.
What Is a Frontside 180 on a Tech Deck?
A frontside 180 is a spin trick where the board jumps, turns 180 degrees, and lands facing the opposite way. Your chest faces forward through the turn, which is what makes it frontside, and you land with your fingers still on the board.

The name comes from real skateboarding. Frontside means your chest faces the direction of the spin, so you can see where you are going. On a Tech Deck your fingers play the role of your feet, and your hand turns with the board as it spins.
A frontside 180 is one of the first spin tricks most riders learn after the ollie. It looks harder than it is, because the spin feels fast at first. Most beginners who can already ollie land a frontside 180 within one to two weeks.
Frontside means your chest faces the spin, so you can see the board through the whole turn. The opposite trick is the backside 180, where your back faces the spin and the landing feels blind at first. Most riders learn the frontside version first because it is easier to see and control.
What Do You Need Before You Learn a Frontside 180?
You should be able to ollie cleanly before you learn a frontside 180. You do not need a high ollie, but you need to pop the tail, lift the board, and land on all four wheels without thinking about it.

- A flat, hard surface. A desk or table is ideal. The board needs to pop and spin freely without catching on carpet or cloth.
- A Tech Deck with free-spinning wheels. If a wheel drags, the board will not spin cleanly and the landing will pull to one side.
- Grip tape with some grip left. Your fingers need to grip the board to turn it. Worn, smooth grip makes the spin slip.
- A little space. The board spins in place, so you do not need a long run-up. Clear the area around it, about 30 cm on each side.
One more thing helps a lot. Practise with your shoulders loose. The spin starts in your shoulders and your hand, not in your fingers alone. If your shoulders are stiff, the spin will be stiff too.
Where Do Your Fingers Go for a Frontside 180?
Finger placement for a frontside 180 is close to ollie placement, with one important change. Your back finger moves to the edge of the tail so it can twist the board, and your front finger stays near the middle to guide the spin.

Step 1: Put Your Middle Finger on the Tail Edge
Place your middle finger on the tail, toward the back edge and slightly to one side. Your fingertip should sit near the corner of the tail, not in the centre. This finger pops the tail and starts the spin, so it needs a spot where it can push and twist.
Step 2: Put Your Index Finger Near the Middle
Place your index finger near the middle of the board, just behind the front bolts. This finger stays light. Its job is to guide the board and catch it after the spin, not to push it. If it presses too hard, it will stop the spin.
Step 3: Wind Up Your Hand Slightly
Turn your hand a little in the opposite direction before you pop, like winding up a spring. A small wind up is enough. Your hand should turn back about 30 degrees, no more. This stores the spin, so the board turns easily when you release it.
Quick test: wind up and pop the tail lightly without landing. If the board starts to turn toward your front, your placement is right.
How Do You Frontside 180 on a Tech Deck Step by Step?
Here is a simple 5 step process to land your first frontside 180. Each step builds on the last one, so practise them in order. Take your time with the spin, because rushing it makes the board wobble.

Step 1: Set Your Fingers and Wind Up
Set your fingers in the position above and wind your hand up a little in the opposite direction. Learn it from a standstill, not rolling, so you can watch the spin without chasing the board. Keep the board flat and your fingers light.
Step 2: Pop the Tail
Pop the tail with your middle finger, the same as an ollie. Push down sharply and let the board rise. The pop gives the board the height it needs to spin, so make it clean and strong.
Tip: the pop and the spin happen together, not one after the other. Pop the tail and unwind your hand in the same moment, like one movement.
Step 3: Turn Your Hand and the Board
As the board rises, unwind your hand toward your front and let the board turn with it. Your middle finger twists the tail, and your index finger guides the nose around. The board should turn smoothly, not in a jerk.
Step 4: Watch for the 180 Degree Turn
Watch the board spin until it has turned halfway around, 180 degrees, and the nose and tail have swapped places. Do not try to catch it early. Let it complete the turn, and keep your eyes on the board the whole time.
Step 5: Catch and Land on All Four Wheels
As the board completes the spin, bring both fingers down over the bolts and catch it. Land on all four wheels at the same time, then roll forward in the new direction. To make it smoother, catch it a fraction earlier each time, until the landing feels soft.
What Are the Most Common Frontside 180 Mistakes?
Most frontside 180 problems come from three mistakes. Fix them one at a time, and the trick gets much easier.

- Not winding up enough. The board only turns 90 degrees and stops. Fix it by winding your hand up a little more before the pop, and by turning your shoulders with your hand. A bigger wind up gives a fuller spin.
- Popping without spinning. The board jumps straight up and lands facing the same way. Fix it by popping and unwinding in the same moment. If you pop first and spin second, the board is already falling before it turns.
- Catching too early. You grab the board halfway through the spin and it lands sideways. Fix it by waiting for the full turn. Watch the graphic on the board. When the nose and tail have swapped places, the board is ready to catch.
One more mistake is common. Riders spin the board with their fingers only, and the turn is weak. Use your whole hand and your wrist, not just your fingertips. The spin comes from the hand, and the fingers only guide it.
If your board keeps landing on two wheels, your catch is uneven. Bring both fingers down at the same time, over the bolts, and the landing will level out.
How Can You Practise the Frontside 180 in 10 Minutes a Day?
A short daily drill works better than a long session once a week. Your hand learns the spin by repeating it, and ten minutes a day is enough to build it in a few weeks.

First, spend two minutes on the wind up alone. Wind up and unwind without popping. This teaches your hand the motion and keeps it smooth.
Second, spend five minutes on slow spins. Pop gently and turn the board slowly, without worrying about the landing. Just watch the spin and learn the timing. Slow spins teach your hand more than fast ones.
Third, spend three minutes on full tries. Pop, spin, and catch. Count how many you land out of ten, and write the number down. Most riders land one in ten in the first week, and three in ten by the third week.
Practise at the same time each day if you can. Your hand remembers the motion better with a regular routine. And take a break if your wrist gets tired. A tired wrist makes sloppy spins, and sloppy spins teach bad habits.
What Should You Learn After the Frontside 180?
A clean frontside 180 opens up a whole set of spin tricks. The wind up and the timing you build here show up again in 360s, boardslides, and flip tricks, all of which use the same spin.

- Backside 180. The same spin in the other direction. Your frontside 180 already taught you the wind up, so the backside version is just a new direction to practise.
- Frontside 360. The full turn, twice as far as the 180. It needs a bigger wind up and a stronger pop, so learn the 180 first. Read our guide on How to Shuvit on a Tech Deck to build the scoop that helps with bigger spins.
- Kickflip. The flip trick that pairs well with a 180, because the landing often flows straight into a flip. Read our guide on How to Kickflip on a Tech Deck when you are ready.
The best next step is to link the frontside 180 with a trick you already know. Ollie into a frontside 180, then roll into a manual. That combo looks smooth, it shows real control, and it is a favourite in fingerboard videos.
For the full list of tricks in order, see our pillar guide to Tech Deck tricks.
What Are the Advantages and Disadvantages of the Frontside 180?
A frontside 180 is a great next trick after the ollie, but it is not perfect for everyone. Here is an honest look at both sides before you start. Knowing both sides helps you practise with the right expectations.

Advantages
- It adds a spin to a trick you already know. The frontside 180 uses the same pop as your ollie, so you are learning a turn, not a whole new trick. That makes it the easiest spin trick to start with.
- You can see the whole turn. Your chest faces the spin, so you can watch the board through the full 180 degrees. That makes the landing easier to judge than a blind backside turn.
- It opens up bigger tricks. The wind up and timing you build here show up again in 360s, boardslides, and flip tricks. The work you put in now pays off fast when you move on.
Disadvantages
- The timing takes time to learn. Most beginners need one to two weeks of daily practice before the spin and the catch feel smooth together. Slow, clean tries in the first week fix this faster than rushing.
- It is easy to catch too early. Grabbing the board halfway through the spin lands it sideways, and that habit is hard to break once it sets in. Wait for the full turn before you bring your fingers down.
- It needs a clean ollie first. If your ollie is shaky, the spin will be shaky too, so you have to fix the ollie before this trick works. Spend a few days on your ollie if the spin keeps falling apart.
What Do Beginners Ask About the Frontside 180?
Here are the questions beginners ask most about the frontside 180. Each answer is short and direct, so you can find your fix fast.
Is a frontside 180 harder than an ollie?
For most people, yes at first. The ollie is just a jump, while the frontside 180 adds a spin and a landing facing the other way. But the pop is the same, so riders who can ollie usually land a frontside 180 within one to two weeks.
How long does it take to learn how to frontside 180 on a Tech Deck?
Most beginners who can already ollie land their first frontside 180 within one to two weeks. A clean frontside 180, with a full spin and a flat four wheel landing, usually takes three to four weeks of ten minute daily practice.
Why does my board only spin 90 degrees?
Your wind up is too small, or you are spinning with your fingers only. Wind your hand up more before the pop, and turn your wrist with your hand. A bigger wind up gives a fuller spin, and the board will turn the full 180 degrees.
Should I learn a frontside 180 rolling or standing still?
Learn it standing still first. The spin is easier to see and catch when the board is not moving forward, and you can focus on the wind up alone. Once you can land it still five times in a row, try it with a slow roll.
What is the difference between a frontside 180 and a backside 180?
A frontside 180 turns toward your front, with your chest facing the spin. A backside 180 turns away from your front, with your back facing the spin. The frontside version is easier to see and control, so most riders learn it first.
Why does my board land sideways?
You are catching it too early, before the spin is done, or your fingers are coming down unevenly. Wait for the full turn, watch the nose and tail swap places, then bring both fingers down at the same time over the bolts.
Do I need to ollie first to learn how to frontside 180 on a Tech Deck?
Yes, you should be able to ollie cleanly first. The frontside 180 is an ollie plus a spin, so the pop has to be automatic before you add the turn. If you cannot ollie yet, spend a few days on it, then come back here.
Can I do a frontside 180 on any Tech Deck?
Yes, any standard Tech Deck works. A board with free spinning wheels and decent grip tape is best. If a wheel drags or the grip is smooth, the spin will be harder. Fix the setup first, then practise the trick.
Conclusion
So, in this article, we covered how to frontside 180 on a tech deck in detail. You learned the finger placement, the wind up, the five steps, the three mistakes that stop most beginners, and a 10 minute drill that builds the trick day by day. You also saw what to learn next.
Here is my honest advice. Do not chase a fast spin in your first week. Spend ten minutes a day on slow, clean frontside 180s, and the speed will come on its own. Your hand is learning a new motion, so give it time and keep the practice slow and steady.
Now go practise your frontside 180 for ten minutes and try to land three clean ones in a row. Once you can do that, try linking an ollie into a frontside 180 and rolling into a manual.
TechDeckTrick.com is an independent guide and is not affiliated with or endorsed by Tech Deck or Spin Master.
