★ THE #1 FINGERBOARD GUIDEMaster Tech Deck Tricks — Ollie Se 360 Flip Tak

The ollie is the easiest Tech Deck trick to learn, and it is the trick every beginner should start with. Place your index finger in the middle of the board and your middle finger on the tail, pop the tail down hard, then slide your index finger forward to level the board in the air. Most beginners land their first ollie in 1-2 weeks with 10 minutes of practice a day. Once your ollie is consistent, move on to the shuvit and the manual — both build directly on the ollie.

With 10 minutes of practice a day, most people learn the ollie in 1-2 weeks and finish the beginner tricks (ollie, shuvit, manual) in 1-2 months. Intermediate tricks like the kickflip and heelflip usually take another 2-4 months, and advanced tricks like the 360 flip can take 6-12 months. Short daily practice works better than one long session a week, because fingerboard tricks are about muscle memory. Follow the tricks in order on this site — skipping ahead to hard tricks only slows you down.

No, a standard Tech Deck in good condition is enough to learn every beginner trick. What matters most is fresh grip tape, trucks that are not loose, and wheels that spin freely — check all three before you blame your fingers. Cheap toy fingerboards with no grip and stiff wheels will make learning much harder, so avoid those. Once you can ollie and shuvit consistently, a real-wood Performance Series board gives better pop and control, but it is not needed to start.

A single Tech Deck board costs around $10-20 in the USA, £8-15 in the UK and €10-20 in Europe. Starter sets with a board and a small ramp cost $20-40, and Build-A-Park sets cost $25-50 depending on the size. Prices vary by shop, so check Amazon, Walmart and Target in the USA, Argos and Smyths in the UK, and Amazon.de or Amazon.fr in Europe. Avoid paying more than this for a standard board — limited editions are the only ones that cost more.

The best Tech Deck for beginners is a standard 96mm Tech Deck single board or a Performance Series board — both have real grip tape, working trucks and a size that fits most hands. Pick a board with a graphic you like, because you will be looking at it for hours while you practise. Avoid pro-model and limited-edition boards at first: they cost more and do nothing extra for a beginner. Start cheap, learn the ollie, shuvit and manual, then upgrade to a real-wood board once you are landing tricks.

Yes, you do not need a skatepark to learn Tech Deck tricks — a table, desk or any flat surface is enough for the ollie, shuvit and manual. Books, boxes and phone stands make perfect beginner obstacles for grinds and slides, and you can practise anywhere. A Build-A-Park set or a small ramp is nice later for grinds and air tricks, but it is not needed to start. Most fingerboarders learn their first 10 tricks on a table at home.

Clean your Tech Deck by wiping the grip tape with a slightly damp cloth to remove dust — never soak the board in water, or the wood will warp. Check the truck screws every few weeks and tighten them with a small screwdriver if the trucks feel loose. Replace the grip tape when it stops feeling rough, and replace the wheels when they stop spinning freely or get flat spots. Store your board in a dry place away from heat, and it will last for years.

No, TechDeckTrick.com is an independent fan and guide site — it is not affiliated with, endorsed by or connected to Tech Deck or Spin Master. All tricks, guides and reviews here are written by fingerboarders for fingerboarders, and Tech Deck is a trademark of Spin Master. For official products and the official shop, visit techdeck.com. This site exists to teach tricks step by step, with finger placement, common mistakes and practice drills you will not find on the official site.